Aftermarket Knobs & Feet for Uniden Scanners Models BC780XLT / BC785D / BC796D

Description

Aftermarket Knobs & Feet for Select Uniden Scanners
BC780XLT / BC785D / BC796D
Are the knobs broken or missing on your BC780XLT / BC785D / BC796D scanner? What about the little rubber feet? This kit contains a set of 3 knobs and 2 feet. All of the parts were designed and produced by us in-house with careful measuring and testing on our own scanner. These are not factory-made parts but are a near perfect replica. The finish is not as smooth as on the factory parts.
Included in the kit:
- One VFO knob in black
- One squelch knob in black
- One volume knob in black
- Two flexible replacement feet in red
Installation is simple:
1. Remove existing knobs and metal sleeves (if present) by pulling straight out. They should come off fairly easily. Retain the parts for future use. Metal sleeves are not used on new knobs.
2. Line up the flat part of the new knob to the flat part on the shaft.
3. Press firmly into place. They are designed to be a very tight fit and it will take some force to install completely. If the squelch knob rubs on the base, raise it up slightly by using a small tool to wedge it up.
4. To remove, use a thin pry tool to pull off.
5. Feet simply slip on with a friction fit. They are a little harder than the factory feet which should help them last longer.
We offer many other custom-made parts for other radio scanners such as the Uniden SDS100 / SDS200 and much more. Take a look at our other listings.
_gsrx_vers_1233 (GS 8.1.1 (1233))